I-view Ethernet/PoE over Coax Extender built-in Hub User Manual download pdf

 Packing Checklist:

Carefully unpack and check the package box if the following items are included:

¾ EOC-110V x 1 ea

¾ EOC-100V x 1 ea

¾ DC12V power adapter x 1 ea

¾ Menu x 1 pc

 Product Feature:

¾ Transmits up to distances of 300 meters ⁄ 660 feet.

¾ Supports any 10/100M Ethernet device, including IP cameras.

¾ Fully transparent to the network.

¾ Easy to install, no IP and MAC address configuration required

 Product Overview:

 Product Application Diagram

 Installation Notes:

¾ Please use 75 Ohm coaxial cable and BNC connector for the data transmission.

¾ Please use less than 2 meters Category 5, 5E or 6 UTP patch cable to connect IP camera or Switch HUB.

¾ Some IP cameras built in pigtail cable which with none standard Cat. 5 UTP cable, it will cause the shorter

transmission distance or no communication. Please confirm this issue to your IP camera vendor.

¾ Please measure the coaxial wire distance, use only transceivers that are designed for that distance.

¾ To avoid the terminator problem, before connecting the LAN cable from EOC device to switching HUB, please

connect the coax cable between both EOC devices and the LAN cable between IP camera & EOC device first.

Ethernet over Coax Extender Installation Guide V1.0

EOC-110V

Female BNC Connector

Attaches to 75Ω coax cable.

RJ-45 Connector

Attaches to Cat5 or Cat6 patch cable.

Power LED (yellow)

Indicate the power status

Power Jack

Plug DC12V power adapter

Female BNC Connector

Attaches to 75Ω coax cable.

RJ-45 Connector

Attaches to Cat5 or Cat6 patch cable

1 2

Page 1

 Packing Checklist: Carefully unpack and check the package box if the following items are included: ¾ EOC-110V x 1 ea ¾ EOC-100V x 1 ea ¾ DC12V

¾ The quality of coaxial cable will reduce or increase the transmission distance. The EOC-100Kit is tested for use with RG-59U 75 Ohm copper based

No comments

I-view Ethernet/PoE over Coax Extender built-in Hub User Manual